Spanning Tree Root Primary

Spanning Tree Root Primary. You can configure this by changing the priority value. Since each switch was at the default spanning tree priority of 32768, sw2 became the root bridge for all vlans.

Stp uses a distributed algorithm that selects one bridge of a redundantly. You can configure it using the root. This command reduces the the switch.

Here Are The Spanning Tree Tasks;

How to configure spanning tree protocol root primary and root secondary for selecting root switch (root bridge) to configure a switch to become the spanning tree protocol (stp). This command reduces the the switch. You can use 2 methods in configuration mode to configure a switch as #root #bridge ;

Stp Uses A Distributed Algorithm That Selects One Bridge Of A Redundantly.

Since each switch was at the default spanning tree priority of 32768, sw2 became the root bridge for all vlans. The cisco switch root secondary command is also very. How to configure spanning tree protocol root primary and root secondary.

The Priority For The Switch.

The vlan's with a lower root value have been set manually on their respective switches. In my case, sw2 is the root bridge for all vlans: You can configure it using the root.

You Can Configure This By Changing The Priority Value.

In this article, i am going to discuss about how to configure spanning tree protocol root primary and root.

Location:

ROOTSE